Leider funktioniert das auch nicht, ich habe mal semtliche überflüssigen programme deinstalliert, ich kann mir das selbst nicht erklären.
Bei der eingabeaufforderung folgende meldung.
Zitat:
Fehler beim Wechseln in den Ruhezustand: Die Anforderung wird nicht unterstützt
Der Wechsel in den Ruhezustand wird durch folgende Elemente im System
verhindert:
Es ist mindestens ein Legacytreiber installiert:
VgaSave
Der Ruhezustand wurde durch eine interne Systemkomponente deaktiviert.
|
Was damit jetzt gemeint ist ?
Hier noch ein Bluescreen Report
Zitat:
A problem has been detected and Windows has been shut down to prevent damage
to your computer.
The problem seems to be caused by the following file: ataport.SYS
KERNEL_MODE_EXCEPTION_NOT_HANDLED
If this is the first time you've seen this stop error screen,
restart your computer. If this screen appears again, follow
these steps:
Check to make sure any new hardware or software is properly installed.
If this is a new installation, ask your hardware or software manufacturer
for any Windows updates you might need.
If problems continue, disable or remove any newly installed hardware
or software. Disable BIOS memory options such as caching or shadowing.
If you need to use safe mode to remove or disable components, restart
your computer, press F8 to select Advanced Startup Options, and then
select Safe Mode.
Technical Information:
*** STOP: 0x1000008e (0xc0000005, 0x874bc487, 0x9ece775c, 0x00000000)
*** ataport.SYS - Address 0x874bc487 base at 0x874b6000 DateStamp 0x4a5bbf16
|
Und noch ein anderen Internal_power_error
Zitat:
A problem has been detected and Windows has been shut down to prevent damage
to your computer.
The problem seems to be caused by the following file: ntkrnlpa.exe
INTERNAL_POWER_ERROR
If this is the first time you've seen this stop error screen,
restart your computer. If this screen appears again, follow
these steps:
Check to make sure any new hardware or software is properly installed.
If this is a new installation, ask your hardware or software manufacturer
for any Windows updates you might need.
If problems continue, disable or remove any newly installed hardware
or software. Disable BIOS memory options such as caching or shadowing.
If you need to use safe mode to remove or disable components, restart
your computer, press F8 to select Advanced Startup Options, and then
select Safe Mode.
Technical Information:
*** STOP: 0x000000a0 (0x00000001, 0x00000006, 0x858aad18, 0x00000000)
*** ntkrnlpa.exe - Address 0x82f15d10 base at 0x82e39000 DateStamp 0x4c1c3fac
|
Ich dreh hier am rad, es ist meist in unregelmäßigen abständen, gestern abend funktionierte es mal etwas länger, beim herrunterfahren war es wieder da. Leider habe ich auch gerad kein Laufwerk zu verfügung. Sonst würd ich win 7 neu installieren.
/edit: Mir ist gerade aufgefallen das ich meine Festplatte im gerätemanager nicht mehr finde.
Dort war sie vorher mit fujitsu siemens ... Vllt was damit zutun ? Oder vllt das ich im abgesicherten modus drine bin ?